Fatigue Life Improvement of DOT-CFFC Composite Cylinders PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
General
Legacy ID
21
Evaluation of Nondestructive Examination for Re-qualification Of Composite Gas
September 30, 2002This Research and Development (R&D) project has been performed to evaluate several NDE methods based on their potential ability to detect common flaws such as impact damage in composite gas cylinders.
Key Words: acoustic emission, radiography, micro/millimeter wave,...
Evaluation of Nondestructive Examination for Re-qualification Of Composite Gas PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
Evaluation of DOT 3AL 6061-T6 Cylinders to Determine the Crack Initiation Site (CIS) Which Were Detected in Cylinder's Neck Threads
August 19, 2010This research project is a part of Failure Investigation and Metallurgical Analysis of DOT 3AL cylinders that were rejected during requalification due to internal neck-cracks. The main purpose of this research was to analyze the cylinder heads in order to determine the crack...
Evaluation of DOT 3AL 6061-T6 Cylinders to Determine the Crack Initiation Site (CIS) Which Were Detected in Cylinder's Neck Threads PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
DOT FRP-2 Standard, Basic Requirements For Fiber Reinforced Plastic Type 3HW Composite Cylinders
January 14, 1987This is the basis requirements (standard) by OHM for design, construction and manufacturing Hoop wrapped Fiber Reinforced Composite (HW) Cylinders (FRP-2).
Key Words: composite cylinder, E glass, S glass, cycling, fiber stress, aluminum liner, hoop, hoop wrapped
If...
DOT FRP-2 Standard, Basic Requirements For Fiber Reinforced Plastic Type 3HW Composite Cylinders PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
DOT FRP-1 Standard, Basic Requirements For Fiber Reinforced Plastic Type 3FC Composite Cylinders
February 17, 1987This is the basis requirements (standard) by OHM for design, construction and manufacturing fully wrapped Fiber Reinforced Plastic Type 3FC Composite Cylinders (FRP-1).
Key Words: composite cylinder, E glass, S glass, cycling, fiber stress, aluminum liner, full wrapped...
DOT FRP-1 Standard, Basic Requirements For Fiber Reinforced Plastic Type 3FC Composite Cylinders PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.