Rupture Evaluation Tests for Mechanical strength and Fracture Toughness for DOT-3AL-6351 T6 Alloy Cylinder PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
General
Legacy ID
21
Procedure for Removal of Nonconforming Hazardous Materials Packagings from Service
July 31, 2007
Used by OHM as the basis for removing nonconforming packagings from service.
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
[NOTE: The attached documents are in PDF format, you can download a...
Procedure for Removal of Nonconforming Hazardous Materials Packagings from Service PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
Pneumatic Pressure Test: Key Largo Cylinder (DOT-3AL-3000 Cylinder J95119)
October 4, 2000
The main purpose of this technical evaluation was to determine the cause of an aluminum cylinder failure in Key Largo, FL.
Key Words: SLC, sustain load crack, SCUBA, DOT 3AL cylinder, fractographic, ruptured cylinder, SEM analysis, ruptured DOT-3AL
If you have...
Pneumatic Pressure Test: Key Largo Cylinder (DOT-3AL-3000 Cylinder J95119) PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
Phase I - Modeling of Current Standards for Selecting Pressure Vessel Steels (DOT Packaging) to Transport Hydrogen-Bearing Gases
August 25, 2016
The goal of this project is to determine which laboratory test method(s) can be used to most reliably evaluate steels for the construction of cylinders and tubes used for transportation and storage of compressed natural gases (CNG), hydrogen and hydrogen-bearing gases. The...
Phase I - Modeling of Current Standards for Selecting Pressure Vessel Steels (DOT Packaging) to Transport Hydrogen-Bearing Gases PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
Neck Threads Inspection: External
July 31, 2007
Basic guidelines for the inspection and evaluation of DOT/TC cylinder (tube) mounting threads with outside diameter greater than or equal 18".
Key Words: neck threads, DOT cylinder, tube, threads, external, inspection
If you have any technical questions not...
Neck Threads Inspection: External PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.