DOT FRP-1 Standard, Basic Requirements For Fiber Reinforced Plastic Type 3FC Composite Cylinders PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
General
Legacy ID
21
Confirmation of Filling Densities
November 1, 2002Listed in the United Nation (UN) Model Regulations, Volume I, Thirteenth revised edition.
This R&D has been performed to ensure safe operation of receptacles and tubes filled in accordance with Table P 200 of the UN Model Regulations, Volume I, Thirteenth revised...
Calculation and Verification of Filling Ratios for Liquified Gases PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
Chemical and Metallurgical Analysis of Ruptured DOT-3AL Specification Compressed Gas Cylinder
June 1, 1994The main purpose of this technical evaluation was to determine the cause of the SCUBA aluminum cylinder failure in North Miami Beach, FL
Key Words: SLC, sustain load crack, SCUBA, DOT 3AL cylinder with gaseous oxygen, ruptured cylinder, SEM analysis
If you have any...
Chemical and Metallurgical Analysis of Ruptured DOT-3AL Specification Compressed Gas Cylinder PDF
If you have any technical questions not addressed by this or associated documents, contact Mark Toughiry, 202-366-4545.
Basic Requirements for Fully Wrapped Carbon-Fiber Reinforced Aluminum Lined Cylinders
March 1, 2007This is the basis requirements (standard) by OHM for design, construction and manufacturing fully wrapped carbon-fiber reinforced cylinders (CFFC).
Key Words: carbon composite, aluminum liner, resins, autofrettage, composite cylinder, aluminum liner, fiber stress, burst, burst...